UK flood barrier supplier since 2012 Sole UK distributor of Water-Gate
Flood protection basics · Guide
Types of flooding, and how each one affects your protection.
Flooding is not one thing. The type of flooding matters, because it changes what protects against it. This page explains the main types and the categories of measure that generally respond to each. It does not set out to say what a specific property needs, which is a separate, site-specific question.
Start here
Water reaches a property by different routes.
Where the water comes from, and the route it takes, is what decides which measure responds to it. Water arriving over the ground at an opening is a different problem from water rising from below, or backing up through the drains.
The four types below cover most flooding that affects individual properties. More than one can affect the same property, which is why this is a general framework rather than a lookup.

Type 01
River (fluvial) flooding.
A watercourse cannot carry the volume of water reaching it, usually after intense or sustained rainfall across its catchment, and spills over or breaches its banks. This affects main rivers and ordinary watercourses alike.
There is often some warning, through Environment Agency flood warnings, and river flooding can be prolonged, sometimes lasting days. It usually arrives over the ground, against the outside of a property.
Typically responds to: flood barriers and flood doors at the openings, sometimes a flood wall or perimeter measure where depth and duration are significant, and recoverability measures where a flood may exceed what resistance alone can hold back. See building a flood wall and flood barriers.

Type 02
Surface water (pluvial) flooding.
Rainfall exceeds what the ground and drainage can absorb or carry away, so water runs across the surface and collects in low spots. It is independent of proximity to a watercourse and can affect almost any location.
Onset is typically fast and the duration often short. It is frequently worsened by hard surfaces and blocked gullies, and usually arrives over the ground at the openings. We have written separately on why surface water flooding is getting worse.
Typically responds to: flood barriers across doors, garages and driveways, and drainage measures such as channel drains and pumps where water needs moving away from a defended line. See flood barriers on block paving and water pumps.

Type 03
Groundwater flooding.
The water table rises to the surface after prolonged wet weather. This particularly affects low-lying ground, land near watercourses, and basements and cellars, because the water rises from below rather than arriving over the surface.
Onset is slow, and groundwater flooding can persist for weeks after the rain stops.
Typically responds to: sump and pump systems rather than barriers, because of the route the water takes. See why you might need a pump behind a barrier or wall and water pumps.

Type 04
Sewer (drain) flooding.
Sewage or surface water escapes through a manhole, gully or drain, or backs up through internal fittings such as toilets, baths and sinks. It can arrive from inside the property as much as outside, and is often triggered by heavy rain overwhelming a combined sewer, or by a blockage. Responsibility for the pipe itself varies, which we cover in who is responsible for a drain or sewer.
Typically responds to: non-return valves positioned correctly on the drainage, rather than barriers, because this water arrives through the pipes. See types of non-return valve, where a non-return valve can be installed and non-return valves.

Managed at a larger scale
Coastal, tidal and rarer sources.
Coastal and tidal flooding happens when a storm surge and a high tide combine to exceed coastal defences, putting low-lying coastal and estuarine land at risk.
Coastal and river flooding are related, which is why the Environment Agency maps them together as flooding from rivers and the sea. In tidal rivers and estuaries a high tide can hold back or raise river levels, and the most serious flooding often comes when high river flows and a high tide or surge coincide. This is a specialist area, usually managed by larger sea and estuary defences rather than property-level products.
The Environment Agency also maps reservoir flooding separately, as the rare but high-consequence case of a reservoir or its dam failing. It is closely monitored and managed, and included in flood planning for areas downstream. Canals can flood if a bank or structure fails, and a burst water main is an occasional local cause. These are unusual, and not something a resistance or resilience product responds to in a typical scheme.
Why the type matters
Three things follow from the type of flooding.
These are what decide whether a measure suits a situation at all.
Warning time
A demountable barrier has to be fitted by someone present, with enough warning. Where warning is short or nobody may be home, a permanent flood door or self-closing airbrick, needing no deployment, is often the better fit.
Depth and duration
For shorter, shallower events, keeping water out can be enough. Where flooding is deep or prolonged, holding water back has its limits, and measures that help a property recover quickly become part of the plan too.
The route in
Over the ground at an opening suits a barrier or flood door; up through the drains suits a non-return valve; rising from below suits a pump. The route decides the measure.
Resistance
When are flood barriers a good idea?
Barriers are a resistance measure: they keep water out at an opening. They tend to suit situations where the water arrives over the ground, where there is warning time to deploy them, or where a permanent flood door suits because there is not, and where depth and duration are within what keeping water out can realistically manage.
The Be Flood Ready campaign frames property flood resilience as protection, keeping water out, and adaptation, recovering faster, working together. Barriers are part of the protection side, and are strongest as part of a plan that has considered both.
Where flood barriers sit
Property flood resilience bridges the gap between large defence schemes and sandbags. It gives an individual property proper, engineered protection where a national scheme is not available and sandbags are not enough. Flood barriers sit in the property flood resilience band.
- Large defence schemes. Engineered walls and embankments that protect many properties. Costly, and not available everywhere.
- Temporary barrier schemes. Deployed along watercourses by the authorities during a flood, where a scheme exists.
- Property flood resilience. Measures fitted to an individual property, covering both resistance and recoverability. Flood barriers, flood doors, anti-flood airbricks, non-return valves and pumps all sit here.
- Sandbags. Widely used, but they do not form a watertight seal. A limited short-term measure, not reliable protection.
- Doing nothing. No management of the risk.
This framing is drawn from the Be Flood Ready flood-protection hierarchy.
Resistance and recovery
Keeping water out is one half of it.
Property flood resilience is protection and recovery working together. Protection, or resistance, keeps water out: barriers, flood doors, airbricks and non-return valves. Recovery, or adaptation, limits damage and speeds the clean-up when water does get in: resilient floors and finishes, raised electrics and services, and moving valuables out of reach.
The balance depends on the flooding. For shorter, shallower events keeping water out can be enough. For deeper or longer floods, where resistance has its limits, recovery becomes as important as resistance. There is more on this in understanding and implementing property flood resilience.
At a glance
The types, side by side.
Every cell below is typical, never a rule. More than one type can affect a property at once, which is why this is a general framework rather than a lookup.
| Flood type | Typical onset or warning | Typical duration | Typical route in | Category that usually responds |
|---|---|---|---|---|
| River (fluvial) | Often some warning | Can be prolonged, sometimes days | Over the ground, at openings | Barriers, flood doors, flood walls |
| Surface water (pluvial) | Typically fast onset | Often short | Over the ground, at openings | Barriers, drainage, pumps |
| Groundwater | Slow onset | Can persist for weeks | Rising from below | Sump and pump systems |
| Sewer (drain) | Often with heavy rain | Varies | Up through the drains | Non-return valves |
| Coastal or tidal | Storm and tide dependent | Varies | Over coastal defences | Specialist area, not mapped here |
The measures
Explore the measures.
Which of these suits a particular site depends on the flooding it actually experiences, and often on more than one type at once.
01
Flood barriers and doors
Resistance at the openings, for water arriving over the ground.
02
Flood walls and perimeter protection
Holding a line away from the building, where depth and duration justify it.
03
Water pumps
Moving water away, and the usual answer where water rises from below.
04
Non-return valves
Stopping water coming back up the drainage into the property.
Before choosing anything
Check your flood risk.
Knowing which types of flooding are relevant to an area is the sensible starting point before choosing any measure. Our guide explains where to check, and what the available information can and cannot tell you.
From general to specific
How a property’s actual risk is established.
This page describes the types of flooding in general. Establishing which apply to a specific property, in what combination and to what severity, is a site-specific flood risk assessment, carried out by FPS Environmental Ltd, the separate consultancy company in the FPS Group.
That is not a step everybody needs. A known opening does not need an assessment before a barrier can be bought and fitted. The assessment answers a different question: which types of flooding affect a property, and what to do about them together.
Questions
Types of flooding, answered.
What are the main types of flooding?
River (fluvial), surface water (pluvial), groundwater and sewer flooding are the main types affecting individual properties. Coastal and tidal flooding, and rarer sources such as reservoirs and canals, are usually managed at a larger scale.
Does the type of flooding change what protects against it?
Yes. The route the water takes decides the measure. Water arriving over the ground at an opening calls for something different from water rising from below or backing up through the drains.
Do flood barriers stop every type of flooding?
No. Barriers seal at openings, so they respond to water arriving over the ground. Sewer flooding typically needs non-return valves, and groundwater typically needs pumps, because that water does not arrive at the opening.
Can a property be affected by more than one type of flooding?
Yes, and it is common. That is why the table above is a general framework rather than a lookup, and why more than one category of measure is often involved.
How do I find out which types affect my property?
Start with our check your flood risk guide, which explains where to look and what those sources do and do not tell you. Establishing which types apply to a specific property, and what to do about them, is the site-specific assessment described above.
Contact us.
If you know the opening you want to protect, tell us about it and we will point you to the right product. If you are not sure which types of flooding affect the property, say so and we will tell you whether an assessment is the sensible next step.
Prefer to talk?
Monday to Friday, 9am to 5pm. For a made-to-measure barrier, use the quotation form on our FPS Barrier, Nautilus, door, driveway or garage barrier pages. It takes the measurements and photographs we need.
Send us a message
We normally reply within one working day.
We use these details to reply to your enquiry. See our Privacy Policy (opens in a new tab).
Please note: flood risk assessments, drainage design and consultancy are handled separately by FPS Environmental Ltd.


